The transfer function C(s)/R(s) of the system block shown below is given by
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Show answer
Answer: D. G1G2/(1 + G1G2H1 + G1G2)
More TNPSC Prelims previous year questions questions
- In the given force equation for the system, M d²(y-x)/dt² + f dy/dt + ky = 0, if α- constant acceleration is applied to the accelerometer then the steady-state displacement 'y' is a measure of
- The acquisition time in sample-hold characteristics of data acquisition system is time required
- In Data Acquisition System, if in pre-amplification circuit, signal levels below a tenth of an mV is needed than the following is used :
- What is the bandwidth required for an F.M. signal in which the modulating frequency is 2 kHz and maximum deviation is 10 kHz?
- A linear displacement transducer (digital) normally uses
- Piezoelectric transducer cannot measure ________ pressure.
- In a transducer, the observed output deviates from the correct value by a constant factor the resulting error is called
- Calculate the sensitivity of a 200 μA meter movement which is to be used as a dc voltmeter. (A) 5kΩ/V (B) 200 kΩ/V (C) 50 kΩ/V (D) 150 kΩ/V (E) Answer not known
All 17,524 TNPSC Prelims previous year questions questions →