If two gears have number of teeth N1 and N2, radii r1 and r2, angular displacements θ1 and θ2 and torques T1 and T2 (received on shaft on second gear), find the valid relation.
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Answer under review: our editors are checking this question. Try the other TNPSC Prelims previous year questions questions meanwhile.
More TNPSC Prelims previous year questions questions
- The transfer function C(s)/R(s) of the system block shown below is given by
- In the given force equation for the system, M d²(y-x)/dt² + f dy/dt + ky = 0, if α- constant acceleration is applied to the accelerometer then the steady-state displacement 'y' is a measure of
- The acquisition time in sample-hold characteristics of data acquisition system is time required
- In Data Acquisition System, if in pre-amplification circuit, signal levels below a tenth of an mV is needed than the following is used :
- What is the bandwidth required for an F.M. signal in which the modulating frequency is 2 kHz and maximum deviation is 10 kHz?
- A linear displacement transducer (digital) normally uses
- Piezoelectric transducer cannot measure ________ pressure.
- In a transducer, the observed output deviates from the correct value by a constant factor the resulting error is called
All 17,524 TNPSC Prelims previous year questions questions →