Ques # : 1 An intrinsic semiconductor at absolute zero temperature: 1) has only a few holes and few electrons. 2) has very large number of holes and electrons 3) behaves like a good conductor 4) behaves like a good insulator
Asked in RPSC Vice Principal/Superintendent ITI Screening Test 2012 VPITI-Electronic-and-Communications
Show answer
Answer: D. behaves like a good insulator
More RPSC Prelims previous year questions questions
- Ques # : 2 In a P-N diode, with the increase of reverse bias, the current :- 1) increase 2) decrease 3) remains constant 4) may increase or decrease depending upon doping
- Ques # : 3 In a BJT, the Ic= 30mA. If β = 100, the base current approximately equals 1) 0.03 mA 2) 300 mA 3) 0.3 mA 4) 30 mA
- Ques # : 4 The value of VBE,sat in pnp Ge transistor typically equals 1) -0.1 Volt 2) -0.3 Volt 3) -0.8 Volt 4) +0.8 Volt
- Ques # : 5 Transistor is usually encapsulated in 1) graphite powder 2) enamel paint 3) epoxy resin 4) Any of these
- Ques # : 6 The JFET can operate in 1) depletion mode only 2) enhancement mode only 3) either depletion or enhancement mode at a time 4) both depletion or enhancement modes simultaneously
- Ques # : 7 The following constitutes an active circuit element 1) FET 2) BJT 3) Diode 4) a current source
- Ques # : 8 In the fabrication of a buried layer n-p-n transistor, the processes involved are 1. diffusion 2. oxidation 3. epitaxy 4. lithography The correct sequence in which these processes are to carried out, is 1) 2, 4, 3, 1 2) 4) 2, 1, 3 3) 2) 4, 1, 3 4) 4, 2, 3, 1
- Ques # : 9 The output current versus input voltage transfer characteristic of an n-channel JFET is such that there is 1) zero current flow at zero input voltage bias 2) current flow only when a positive input threshold voltage is crossed. 3) current flow only when a negative input cut-off voltage bias is crossed. 4) no cut-off input voltage