Ques #:17 Which one of the following circuits is most suitable as an oscillator at a frequency of 100 Hz? 1) Hartley oscillator 2) Colpitts oscillator 3) Crystal oscillator 4) Twin-T oscillator
Asked in RPSC Vice Principal/Superintendent ITI Screening Test 2012 VPITI-Electronic-and-Communications
Show answer
Answer: D. Twin-T oscillator
More RPSC Prelims previous year questions questions
- Ques #:18 The power input to an amplifier is 2 μW. The power gain of the amplifier is 40dB. The output power of the amplifier is 1) 80 μW 2) 200 μW 3) 20 μW 4) 80 MW
- Ques #:19 Which one of the following sets of circuits can be obtained by using a 555 timer ? 1) Pulse modulator and amplitude demodulator 2) Pulse modulator and astable multivibrator 3) Amplifier demodulator and a.c. to d.c. converter 4) a.c. to d.c. converter and astable multivibrator
- Ques #:20 The common mode error voltage in a DVM can be eliminated by using at its input 1) a differential amplifier 2) a wide band amplifier 3) a tuned amplifier 4) a low pass filter
- Ques #:21 An OR gate may be imagined as 1) switches connected in series 2) switches connected in parallel 3) MOS transistors connected in series 4) None of these
- Ques #:22 Which of the following logic gates dissipates minimum power 1) RTL 2) TTL 3) MOS 4) ECL
- The fan out TTL logic gate is about
- Consider the following statements regarding registers and latches: 1. Registers are made of edge-triggered FFs, whereas latches are made from level-triggered FFs. 2. Registers are temporary storage devices whereas latches are not. 3. A latch employs cross-coupled feedback connections. 4. A register stores a binary word whereas a latch does not. Which of the statements given above are correct
- Consider the following shift right register : The initial contents of the 4-bit serial-in parallel-out, shift right register shown are 0110. What will be the contents of the register after 3 clock pulses are applied