Ques #:18 The power input to an amplifier is 2 μW. The power gain of the amplifier is 40dB. The output power of the amplifier is 1) 80 μW 2) 200 μW 3) 20 μW 4) 80 MW
Asked in RPSC Vice Principal/Superintendent ITI Screening Test 2012 VPITI-Electronic-and-Communications
Show answer
Answer: B. 200 μW
More RPSC Prelims previous year questions questions
- Ques #:19 Which one of the following sets of circuits can be obtained by using a 555 timer ? 1) Pulse modulator and amplitude demodulator 2) Pulse modulator and astable multivibrator 3) Amplifier demodulator and a.c. to d.c. converter 4) a.c. to d.c. converter and astable multivibrator
- Ques #:20 The common mode error voltage in a DVM can be eliminated by using at its input 1) a differential amplifier 2) a wide band amplifier 3) a tuned amplifier 4) a low pass filter
- Ques #:21 An OR gate may be imagined as 1) switches connected in series 2) switches connected in parallel 3) MOS transistors connected in series 4) None of these
- Ques #:22 Which of the following logic gates dissipates minimum power 1) RTL 2) TTL 3) MOS 4) ECL
- The fan out TTL logic gate is about
- Consider the following statements regarding registers and latches: 1. Registers are made of edge-triggered FFs, whereas latches are made from level-triggered FFs. 2. Registers are temporary storage devices whereas latches are not. 3. A latch employs cross-coupled feedback connections. 4. A register stores a binary word whereas a latch does not. Which of the statements given above are correct
- Consider the following shift right register : The initial contents of the 4-bit serial-in parallel-out, shift right register shown are 0110. What will be the contents of the register after 3 clock pulses are applied
- The output voltage of a 5-bit DAC that has a digital input of 11010 (Assuming 0 = 0V and 1 = +10V) is