Ques # :66 Endurance limit or fatigue limit is the maximum stress that a member can withstand for a infinite number of load applications without failure when subjected to 1) Dynamic loading 2) Static loading 3) Combined static and dynamic loading 4) Completely reversed loading
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Mechanical Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :67 Lewis correlation is used to determine which of the following 1) Fatigue Stress 2) Tensile stress in bending 3) Shear stress 4) Compressive stress in bending
- Ques # :68 The lip angle of a single point tool is usually 1) 60° to 80° 2) 40° to 60° 3) 20° to 40° 4) None of these
- Ques # :69 Cast iron during machining produces 1) Discontinuous chips 2) Continuous chips 3) None of these 4) Continuous chips with built up edge
- Ques # :70 In D.C. reverse polarity arc welding : 1) The W.P. is made positive and the electrode is made negative 2) The W.P. is made negative and the electrode is made positive 3) Both the W.P. and the electrode are made positive 4) Both the W.P. and the electrode are made negative
- Ques # :71 Which of the following statement is correct regarding grinding of high carbon steel? 1) Grinding at high speed results in the reduction of chip thickness and cutting forces per grit. 2) The grinding wheel has to be of open structure. 3) Aluminum oxide wheels are employed. 4) All of these
- Ques # :72 During transverse vibrations, shaft is subjected to which type of stresses? 1) Tensile stresses 2) Torsional shear stress 3) Bending stresses 4) All the these
- Ques # :73 A medium carbon steel workpiece is turned on a lathe at 50 m/min cutting speed, 0.8 mm/rev feed and 1.5 mm depth of cut, what is the rate of metal removal : 1) 100 mm³ / min 2) 20000 mm³/ min 3) 60000 mm³/ min 4) Data insufficient
- Ques # :74 In milling machine, the cutting tool is held in position by : 1) Chuck 2) Spindle 3) Arbor 4) Tool holder