Ques # :74 In milling machine, the cutting tool is held in position by : 1) Chuck 2) Spindle 3) Arbor 4) Tool holder
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Mechanical Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: C. Arbor
More RPSC Prelims previous year questions questions
- Ques # :75 Consider the following statement regarding fixtures employed for holding work piece during machining (i) The location is based on 3-2-1 principle, (ii) The number refers to pins employed in three mutually perpendicular planes to arrest all the degree of freedom (iii) Fixtures also provides the tool guidance 1) (i), (ii) and (iii) are true 2) (ii) and (iii) are true 3) (i) and (iii) are true 4) (i) and (ii) are true
- Ques # :77 A hole size 30.00+0.03 mm. The corresponding shaft is of size 30.00+0.08 mm. The resulting assembly has 1) Interference fit 2) Transition fit 3) Clearance fit 4) None of these
- Ques # :78 Which one of the following instruments is used for conducting alignment tests ? 1) Strain gauge 2) Dial gauge 3) Dynamometer 4) Tachometer
- Ques # :79 Interferometry is used to measure 1) Straightness 2) Flatness 3) Roundness 4) Angularity
- Ques # :80 The angle on which the strength of the tool depends is 1) Lip angle 2) Clearance angle 3) Rake angle 4) Cutting angle
- Ques # :81 The factor responsible for the formation of continuous chips with built up edge is 1) High cutting speed and large rake angle 2) High cutting speed and small rake angle 3) Low cutting speed and large rake angle 4) Low cutting speed and small rake angle
- Ques # :82 The interpolator in a CNC machine controls 1) Spindle Speed 2) Coolant flow 3) Feed rate 4) Tool change
- Ques # :83 Two and half axis control in NC machines means 1) Control of three axis simultaneously 2) Control of two axis and spindle speed simultaneously 3) Control of two axis simultaneously and one axis independently 4) Control of two axis simultaneously and one axis is stationary