Ques # :67 Lewis correlation is used to determine which of the following 1) Fatigue Stress 2) Tensile stress in bending 3) Shear stress 4) Compressive stress in bending
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Mechanical Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: B. Tensile stress in bending
More RPSC Prelims previous year questions questions
- Ques # :68 The lip angle of a single point tool is usually 1) 60° to 80° 2) 40° to 60° 3) 20° to 40° 4) None of these
- Ques # :69 Cast iron during machining produces 1) Discontinuous chips 2) Continuous chips 3) None of these 4) Continuous chips with built up edge
- Ques # :70 In D.C. reverse polarity arc welding : 1) The W.P. is made positive and the electrode is made negative 2) The W.P. is made negative and the electrode is made positive 3) Both the W.P. and the electrode are made positive 4) Both the W.P. and the electrode are made negative
- Ques # :71 Which of the following statement is correct regarding grinding of high carbon steel? 1) Grinding at high speed results in the reduction of chip thickness and cutting forces per grit. 2) The grinding wheel has to be of open structure. 3) Aluminum oxide wheels are employed. 4) All of these
- Ques # :72 During transverse vibrations, shaft is subjected to which type of stresses? 1) Tensile stresses 2) Torsional shear stress 3) Bending stresses 4) All the these
- Ques # :73 A medium carbon steel workpiece is turned on a lathe at 50 m/min cutting speed, 0.8 mm/rev feed and 1.5 mm depth of cut, what is the rate of metal removal : 1) 100 mm³ / min 2) 20000 mm³/ min 3) 60000 mm³/ min 4) Data insufficient
- Ques # :74 In milling machine, the cutting tool is held in position by : 1) Chuck 2) Spindle 3) Arbor 4) Tool holder
- Ques # :75 Consider the following statement regarding fixtures employed for holding work piece during machining (i) The location is based on 3-2-1 principle, (ii) The number refers to pins employed in three mutually perpendicular planes to arrest all the degree of freedom (iii) Fixtures also provides the tool guidance 1) (i), (ii) and (iii) are true 2) (ii) and (iii) are true 3) (i) and (iii) are true 4) (i) and (ii) are true