Consider the following statements about a nozzle: 1. In a nozzle, decrease in enthalpy is converted into kinetic energy. 2. In general, for nozzles, it is assumed that change in potential energy and heat transfer is negligible. 3. In nozzles, pressure changes but enthalpy remains constant. Which of the above statements are correct?
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: A. 1 and 2 only
This previous-year question came without the commission's answer key; the answer was checked by AI. Always confirm with the official key.
More GPSC Prelims previous year questions questions
- One kg of water (Cp = 4.187 kJ/kg.K) at 273 K is brought into contact with a heat reservoir at 373 K. When the water reaches 373 K, the entropy change of water is
- Match the following: List-I List-II 1. Clausius statement (a) Heat engine 2. Kelvin-Planck statement (b) Refrigerator 3. PMM-I (c) Violates second law of thermodynamics 4. PMM-II (d) Violates first law of thermodynamics The correct match is:
- The percentage change in volume of a steel bar (Modulus of Elasticity = 205 GPa, Poisson's ratio = 0.3) of 20 mm diameter and 600 mm length when a tensile stress of 180 MPa is applied along its longitudinal axis
- Consider the following statements: Statement I: For a cantilever beam carrying a uniformly varying load (UVL), the shear force diagram is parabolic. Statement II: For a cantilever beam carrying a uniformly varying load (UVL), the bending moment diagram is cubic. Which of the following is correct?
- A long rod of uniform rectangular section is bent to form a circular arc. The thickness of the section is t, length of the rod is l and the displacement of the midpoint is d (where d ≪ l). The maximum longitudinal strain developed in the rod is:
- Consider the following statements for a cantilever beam carrying a point load W at the free end: Statement I: Maximum bending moment occurs at the fixed end. Statement II: Maximum deflection occurs at the free end. Statement III: Slope at the free end is WL2/3E . Statement IV: Deflection at the free end is WL3/2EI . Which of the above statements are correct?
- Consider the following statements regarding a circular shaft (G = Shear Modulus of the material, J = Polar Moment of Area, T = Applied Torque, θ = Angle of Twist, L = Length of the shaft): Statement I: Torsional rigidity of a shaft is given by GJ. Statement II: Torsional stiffness of a shaft is given by GJ/L . Statement III: Torsional stiffness of a shaft is equal to T/θ. Which of the above statements are correct?
- Consider the following statements: Statement I: Tendency of knock increases with advanced spark timing. Statement II: Advanced spark timing increases the pressure and temperature of the unburnt end-gas, promoting its auto-ignition. The correct option is