Ques #: 1 In casting process, which of the following cross section is preferred for runner? 1) Square 2) Rectangular 3) Trapezoidal 4) Circular
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: C. Trapezoidal
More RPSC Prelims previous year questions questions
- Ques #: 2 Thickness of slush casting process is given by t = 0.577t^0.5 + 0.413. After pouring metal if we immediately invert the mould then what is the thickness of casting? 1) 0 2) 0.413 3) 0.99 4) 1.567
- Ques #: 4 Cycle time of resistance welding consists of 1) Squeeze time, weld time, hold time & on time 2) On time, weld time , hold time & off time 3) On time, weld time & off time 4) Squeeze time, weld time, hold time & off time
- Ques #: 5 Go gauge is made for ______ limit to inspect hole size . 1) Maximum material 2) Minimum material 3) Intermediate material 4) Optimum material
- Ques #: 6 Tool life equation for tools under consideration are as follows- HSS: VT^0.2 = 150, Carbide: VT^0.3 = 250, where V is cutting speed in m/min and T is the tool life in min. The breakeven cutting speed above which the carbide tool will be beneficial is:- 1) 54 m/min 2) 150 m/min 3) 194 m/min 4) 250 m/min
- Ques #: 7 When the ordering cost is increased to 4 times,the Economic Order Quantity(EOQ) will be increased to : 1) 2 times 2) 3 times 3) 8 times 4) Remains same
- Ques #: 8 The time taken to drill a hole through a 25 mm thick plate with the drill rotating at 300 rpm and moving at a feed rate of 0.25 mm/rev is:- 1) 10 sec 2) 20 sec 3) 60 sec 4) 100 sec
- Ques #: 9 The method of classification of items to be adopted for spare parts inventory is : 1) ABC analysis 2) XYZ analysis 3) VED analysis 4) SDE analysis
- Ques #: 10 In rolling process, sheet of 25 mm thickness is rolled to 20 mm thickness. Roll is of diameter 600 mm and it rotates at 100 rpm. The rod strip contact length will be 1) 5 mm 2) 39 mm 3) 78 mm 4) 120 mm