Ques # :100 The design wind speed depends upon (a) risk coefficient (b) topography of the area (c) size of the structure of the above, 1) (a) , (b) are correct 2) (b) , (c) are correct 3) (c) , (a) are correct 4) (a) , (b) and (c) are correct
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Civil Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: D. (a) , (b) and (c) are correct
More RPSC Prelims previous year questions questions
- Ques #: 1 In casting process, which of the following cross section is preferred for runner? 1) Square 2) Rectangular 3) Trapezoidal 4) Circular
- Ques #: 2 Thickness of slush casting process is given by t = 0.577t^0.5 + 0.413. After pouring metal if we immediately invert the mould then what is the thickness of casting? 1) 0 2) 0.413 3) 0.99 4) 1.567
- Ques #: 4 Cycle time of resistance welding consists of 1) Squeeze time, weld time, hold time & on time 2) On time, weld time , hold time & off time 3) On time, weld time & off time 4) Squeeze time, weld time, hold time & off time
- Ques #: 5 Go gauge is made for ______ limit to inspect hole size . 1) Maximum material 2) Minimum material 3) Intermediate material 4) Optimum material
- Ques #: 6 Tool life equation for tools under consideration are as follows- HSS: VT^0.2 = 150, Carbide: VT^0.3 = 250, where V is cutting speed in m/min and T is the tool life in min. The breakeven cutting speed above which the carbide tool will be beneficial is:- 1) 54 m/min 2) 150 m/min 3) 194 m/min 4) 250 m/min
- Ques #: 7 When the ordering cost is increased to 4 times,the Economic Order Quantity(EOQ) will be increased to : 1) 2 times 2) 3 times 3) 8 times 4) Remains same
- Ques #: 8 The time taken to drill a hole through a 25 mm thick plate with the drill rotating at 300 rpm and moving at a feed rate of 0.25 mm/rev is:- 1) 10 sec 2) 20 sec 3) 60 sec 4) 100 sec
- Ques #: 9 The method of classification of items to be adopted for spare parts inventory is : 1) ABC analysis 2) XYZ analysis 3) VED analysis 4) SDE analysis