Ques # :94 For design of slabs, IS456 specifies effective span to overall depth ratios, this is to safeguard mainly :- 1) Strength Criterion 2) Deflection Criterion 3) Crack widths 4) Temperature stresses
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Civil Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: B. Deflection Criterion
More RPSC Prelims previous year questions questions
- Ques # :95 Specify the percentage increase in load carrying capacity (specified in IS456) for a column having longitudinal reinforcement tied with spirals as compared to the allowable load for it with lateral ties :- 1) 10% 2) 20% 3) 25% 4) 5%
- Ques # :96 Which of the following types of losses of prestressing occurs only in pretensioning and not in post-tensioning case :- 1) Friction 2) Creep of concrete 3) Relaxation of stress in steel 4) Elastic shortening (deformation) of concrete
- Ques # :97 The effective length of the fillet weld is :- 1) 0.7 X total length 2) total length - √2 X weld size 3) total length - 2 X throat size 4) total length - 2 X weld size
- Ques # :98 For same load, unsupported length and end conditions a laced column as compared to a battened column :- 1) is stronger 2) is weaker 3) is equally strong 4) cannot be compared
- Ques # :99 Consider the following statements :- Bearing stiffeners are provided in a plate girder (a) to avoid local bending failure of flange (b) to prevent buckling of web (c) to strengthen the web (d) under uniformly distributed loads. Which of these statements are correct ? 1) (a) , (b) and (c) 2) (b) and (c) 3) (a) , (c) and (d) 4) (a) , (b) and (d)
- Ques # :100 The design wind speed depends upon (a) risk coefficient (b) topography of the area (c) size of the structure of the above, 1) (a) , (b) are correct 2) (b) , (c) are correct 3) (c) , (a) are correct 4) (a) , (b) and (c) are correct
- Ques #: 1 In casting process, which of the following cross section is preferred for runner? 1) Square 2) Rectangular 3) Trapezoidal 4) Circular
- Ques #: 2 Thickness of slush casting process is given by t = 0.577t^0.5 + 0.413. After pouring metal if we immediately invert the mould then what is the thickness of casting? 1) 0 2) 0.413 3) 0.99 4) 1.567