The circuit turn off-time for a 3-phase full-converter connected to a three phase supply voltage of 230 V, 50 Hz is
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Answer under review: our editors are checking this question. Try the other TNPSC Prelims previous year questions questions meanwhile.
More TNPSC Prelims previous year questions questions
- In a half-wave or full wave voltage multiplier circuit, the correct option is
- PID controllers are tuned based on the frequency response of the closed-loop system by
- The undamped natural frequency of closed loop response with Wn = 0.4472 rad/s ; damping factor ζ = 0.22 and steady state error e1(∞) = 0 will be
- If two gears have number of teeth N1 and N2, radii r1 and r2, angular displacements θ1 and θ2 and torques T1 and T2 (received on shaft on second gear), find the valid relation.
- The transfer function C(s)/R(s) of the system block shown below is given by
- In the given force equation for the system, M d²(y-x)/dt² + f dy/dt + ky = 0, if α- constant acceleration is applied to the accelerometer then the steady-state displacement 'y' is a measure of
- The acquisition time in sample-hold characteristics of data acquisition system is time required
- In Data Acquisition System, if in pre-amplification circuit, signal levels below a tenth of an mV is needed than the following is used :
All 17,524 TNPSC Prelims previous year questions questions →