31 Which of the following method of mining is applicable only to metal mining?
Asked in HPSC to Final Answer Key of the Master Question Booklet of the Screening Test for the Posts of Mining Officer (Advt. No. 08/) & Assistant Mining Engineer (Advt No. 09/) 2023
Show answer
Answer: A. Sublevel Caving Method
More HPSC Prelims previous year questions questions
- 34 A mine has to drive in a vein deposit of strike length 2.8 km, width of 7 m with a road header. The average production capacity of the road header is 30 m3/hr with an average effective monthly cutting hour of 255. The planned largest plying machine requires an excavation height of 5 m. The time in months (rounded up to nearest whole number) required to complete the drive development work is :
- 35 Which of the following methods uses two different plastic tubes for installation of cable bolts?
- 36 Statements related to choice of location of a vertical shaft are given below. (1) Its location should be such that the transportation cost should be minimum. (2) There is competent rock mass. (3) Shaft location depends on size of a shaft pillar. (4) The shaft locations should not be hindered by the surface features.
- 37 High production rate coupled with large scale and extensive subsidence results from the method of
- 38 The equipment that is not used in hard rock metal mining drivage is
- 39 A void of 1800 m3 was formed during production of 5600 tons of copper ore in a stoping block. If the specific gravity of dry mill tailings used for backfilling the void is 2.6, then assuming dry conditions, what is the quantity of tailing (in tons) that would remain surplus after filling the same void:
- 40 Statements related to the context of permanent lining of shafts are given below- (1) Permanent lining is not required where the shaft sides are very strong and competent. (2) The shaft lining, in general, is constructed from top to bottom. (3) Only brick is used as permanent lining. (4) Shotcrete is also a type of permanent lining.
- 41 Statements on Shaft construction are - (1) Cementation sinking method is used for weak and watery rock medium. (2) Grab is a common loading equipment used in shaft sinking. (3) Freezing method is a very common method of shaft sinking. (4) Blasting cannot be adopted for sinking shaft due to accumulation of water.