37 High production rate coupled with large scale and extensive subsidence results from the method of
Asked in HPSC to Final Answer Key of the Master Question Booklet of the Screening Test for the Posts of Mining Officer (Advt. No. 08/) & Assistant Mining Engineer (Advt No. 09/) 2023
Show answer
Answer: B. Block caving
More HPSC Prelims previous year questions questions
- 38 The equipment that is not used in hard rock metal mining drivage is
- 39 A void of 1800 m3 was formed during production of 5600 tons of copper ore in a stoping block. If the specific gravity of dry mill tailings used for backfilling the void is 2.6, then assuming dry conditions, what is the quantity of tailing (in tons) that would remain surplus after filling the same void:
- 40 Statements related to the context of permanent lining of shafts are given below- (1) Permanent lining is not required where the shaft sides are very strong and competent. (2) The shaft lining, in general, is constructed from top to bottom. (3) Only brick is used as permanent lining. (4) Shotcrete is also a type of permanent lining.
- 41 Statements on Shaft construction are - (1) Cementation sinking method is used for weak and watery rock medium. (2) Grab is a common loading equipment used in shaft sinking. (3) Freezing method is a very common method of shaft sinking. (4) Blasting cannot be adopted for sinking shaft due to accumulation of water.
- 42 The sales value of chromite ore from an open pit mine is Rs. 8000 per tonne. Cost of mining, excluding stripping cost, is Rs. 3500 per tonne. The cost of stripping is Rs. 1200 per m3. Assuming profit margin to be zero, the breakeven stripping ratio in m3/tonne is:
- 43 In an opencast coal mine, eight trucks are assigned for one shovel. The shovel loading time per truck is 6 min, and truck cycle time is 22 min. The match factor is:
- 44 A 18 m3 dragline is deployed in an O.B. bench of an opencast mine. Assuming it works for 50 days at the rate of 5 hrs per shift an d 3 shifts per day with the cycle time, bucket fill factor, and operating efficiency of the dragline being 55s, 0.8 and 80% respectively. The total volume of O.B. in m3 handled by the dragline is:
- 45 A drive shaft of an engine develops torque of 600 N-m. It rotates at a constant speed of 49 rpm. The power transmitted by the shaft in kW is: